✨ Guidelines for DIY Lash Application
- Styling is completely safe during pregnancy and breastfeeding.
- The application is also suitable for contact lens wearers.
- It is recommended to wait at least 4–6 weeks after removing salon extensions before applying DIY clusters.
- Avoid using clusters immediately after an eyelash lift, lamination, or henna treatment.
- On weakened or sparse lashes the effect may not be long-lasting - in such a case, we strongly advise against use.
- Factors such as excessive tearing, eye sensitivity, or hormonal disorders (e.g., PCOS, insulin resistance, thyroid conditions) may affect the durability of the final look.
✨ Tips & Tricks for Perfect Application
- Apply clusters only before noon (This allows the glue to cure fully while you are awake).
- Avoid greasy creams and oils in the eye area.
- Do you have straight lashes? Gently curl them with an eyelash curler.
- Apply Bond and Seal only to the base of the lashes, using a very thin layer.
- For outer corners, you may slightly touch the clusters with Bond for extra hold.
- Place the clusters overlapping, without leaving any gaps between them.
- Before clamping the clusters, coat the tip of the applicator with Sealer.
- To refresh longevity, apply Sealer every 2–3 days.
- Avoid saunas, hot baths and sleeping directly on your face.
- For the health of your lashes, do not wear a single application for longer than 7 days.
- Immediately clean the applicator after use before the Sealer dries.
- Always close products tightly to extend their freshness and shelf life.
✨ How to Recognize Errors
- Hard feeling → Too much Seal was applied.
- Sticky feeling → Too much Bond was applied.
- Prickly feeling → Clusters were placed too close to the eye's corner or the waterline.